XFP 10G 1310nm 10km Transceiver | F-tone 北亿纤通

Features:

Support multi protocol from 9.95Gb/s to 11.3Gb/s
Hot pluggable 30 pin connector
Compliant with XFP MSA
Transmission distance of 10km over Single mode fiber
1310nm DFB laser transmitter.
Duplex LC connector
2-wire interface for management and diagnostic monitor
XFI electrical interface with AC coupling
Single power supply voltages: +3.3V
Temperature range 0°C to 70°C
Power dissipation: <1.5W
RoHS Compliant Part

Applications:

10GBASE-LR/LW Ethernet
SONET OC-192 /SDH
1200-SM-LL-L 10G Fiber Channel
Other optical links

Transceiver Types:

XFP 10G 1310nm 10km Transceiver

Hot Pluggable, Duplex LC, 1310nm, DFB LD, Single mode

FXPD-10G10-31

Description:

F-tone’s FXPD-10G10-31 Small Form Factor 10Gb/s (XFP) transceivers are compliant with the current XFP Multi-Source Agreement (MSA) Specification. They comply with 10-Gigabit Ethernet 10GBASE-LR/LW per IEEE 802.3ae and10GFiber Channel 1200-SM-LL-L. Digital diagnostics functions are available via a 2-wire serial interface, as specified in the XFP MSA.

Absolute Maximum Ratings

Parameter	Symbol	Min	Max	Unit
Storage Temperature	TST	-40	+85	℃
Case Operating Temperature	TIP	0	+70	℃
Supply Voltage	VCC3	-0.5	+4.0	V

Electrical Characteristics (TOP= 0 to70 °C)

Parameter	Symbol	Min	Typ	Max	Unit	Note
Supply Voltage	Vcc3	3.13		3.45	V
Supply Current	Icc3			400	mA
Module total power	P			2	W
Transmitter
Input differential impedance	Rin		100		Ω	1
Differential data input swing	Vin,pp	150		820	mV
Transmit Disable Voltage	VD	2.0		Vcc	V
Transmit Enable Voltage	VEN	GND		GND+ 0.8	V
Transmit Disable Assert Time	T_off			100	ms
Tx Enable Assert Time	T_on			100	ms
Receiver
Differential data output swing	Vout,pp	300	500	850	mV
Data output rise time	tr			35	ps	2
Data output fall time	tf			35	ps	2
LOS Fault	VLOS fault	Vcc – 0.5		Vcc HOST	V	3
LOS Normal	VLOS norm	GND		GND+0.5	V	3
Power Supply Rejection	PSR	See Note 4 below				4

Notes

1. After internal AC coupling.

2. 20 – 80 %

3.Loss of Signal is open collector to be pulled up with a 4.7k – 10kohm resistor to 3.15 – 3.6V. Logic 0 indicates normal operation; logic 1 indicates no signal detected.

4. Per Section 2.7.1. in the XFP MSA Specification.

Optical Parameters (TOP= 0 to70°C)

Parameter	Symbol	Min	Typ	Max	Unit	Ref.
Transmitter
Operating Date Rate	BR	9.95		11.3	Gb/s
Bit Error Rate	BER			10-12
Maximum Launch Power	PMAX	-8.2		0.5	dBm	1
Optical Wavelength	λ	1260	1310	1355	nm
Optical Extinction Ratio	ER	3.5			dB
Spectral Width@-20dB	Δλ			1	nm
Sidemode Suppression ratio	SSRmin	30			dB
Rise/Fall Time (20%~80%)	Tr/Tf			35	ps
Average Launch power of OFF Transmitter	POFF			-30	dBm
Tx Jitter	Txj	Compliant with each standard requirement
Optical Eye Mask		IEEE802.3ae				2
Receiver
Operating Date Rate	BR	9.95		11.3	Gb/s
Receiver Sensitivity	Sen			-12.6	dBm	2
Maximum Input Power	PMAX	0			dBm	2
Optical Center Wavelength	λC	1260		1355	nm
Receiver Reflectance	Rrx			-12	dB
LOS De-Assert	LOSD			-13	dBm
LOS Assert	LOSA	-30			dBm
LOS Hysteresis	LOSH	0.5		5	dB

Notes:

1. The optical power is launched into SMF.

2. Measured with a PRBS 231-1 test pattern @10.3125Gbps BER<10-12.

Pin Assignment

Diagram of Host Board Connector Block Pin Numbers and Name

Mechanical Dimensions

工作温度：商业级/工业级/军品级可选

本产品为北亿纤通 | F-tone Networks FT-81系列产品线，详细信息，请联系我们的销售人员，谢谢！Important Notice Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by Andxe System before they become applicable to any particular order or contract. In accordance with the Andxe System policy of continuous improvement specifications may change without notice.The publication of information in this data sheet does not imply freedom from patent or other protective rights of Andxe System or others. Further details are available from any Andxe System sales representative.

相关产品推荐