Features:
- Up to 155Mb/s Data Links
- Hot-Pluggable
- Duplex LC connector
- Up to 120km on 9/125μm SMF
- 1270nm～1610nm CWDM DFB laser transmitter
- Single +3.3V Power Supply
- Monitoring Interface Compliant with SFF-8472
- Maximum Power <1W
- Industrial /Extended/ Commercial operating temperature range:
- -40°C to 85°C/-5°C to 85°C/-0°C to 70°C Version available
- RoHS compliant and Lead Free
Applications:
- SONET OC-3/SDH STM-1
- Fast Ethernet
- Other Optical Links
RSPD-01C120-XX
155Mb/s 120km CWDM SFP Transceiver
Hot Pluggable, Duplex LC, +3.3V, 1270nm～1610nm, CWDM DFB-LD, Single-mode, DDM
Description:
F-tone’s FSPD-01C120-xxTransceiver is a high performance, cost effective module which have a duplex LC optics interface. Standard AC coupled CML for high speed signal and LVTTL control and monitor signals. The receiver section uses a PIN receiver and the transmitter uses a 1270nm～1610nm CWDM DFB laser, up to 29dB link budge ensure this moduleSONETOC-3/SDHSTM-1 120km application.
Absolute Maximum Ratings
|
Parameter |
Symbol |
Min. |
Typical |
Max. |
Unit |
|
Storage Temperature |
TS |
-40 |
|
+85 |
°C |
|
Supply Voltage |
VCC |
-0.5 |
|
4 |
V |
|
Relative Humidity |
FH |
0 |
|
85 |
% |
Recommended Operating Environment
|
Parameter |
Symbol |
Min. |
Typical |
Max. |
Unit |
|
|
Case operating Temperature |
Industrial |
TC |
-40 |
|
85 |
°C |
|
Extended |
-5 |
|
85 |
°C |
||
|
Commercial |
0 |
|
+70 |
°C |
||
|
Supply Voltage |
VCC |
3.135 |
|
3.465 |
V |
|
|
Supply Current |
Icc |
|
|
300 |
mA |
|
|
Inrush Current |
Isurge |
|
|
Icc+30 |
mA |
|
|
Maximum Power |
Pmax |
|
|
1 |
W |
|
Electrical Characteristics(TOP =-40 to85°C, VCC = 3.135 to 3.465 Volts)
|
Parameter |
Symbol |
Min. |
Typical |
Max. |
Unit |
Note |
|
Transmitter Section: |
|
|||||
|
Input differential impedance |
Rin |
90 |
100 |
110 |
W |
1 |
|
Single ended data input swing |
Vin PP |
250 |
|
1200 |
mVp-p |
|
|
Transmit Disable Voltage |
VD |
Vcc – 1.3 |
|
Vcc |
V |
2 |
|
Transmit Enable Voltage |
VEN |
Vee |
|
Vee+ 0.8 |
V |
|
|
Transmit Disable Assert Time |
Tdessert |
|
|
10 |
us |
|
|
Receiver Section: |
|
|||||
|
Single ended data output swing |
Vout,pp |
300 |
|
800 |
mv |
3 |
|
Data output rise time |
tr |
|
|
500 |
ps |
4 |
|
Data output fall time |
tf |
|
|
500 |
ps |
4 |
|
LOS Fault |
Vlosfault |
Vcc – 0.5 |
|
VCC_host |
V |
5 |
|
LOS Normal |
Vlos norm |
Vee |
|
Vee+0.5 |
V |
5 |
|
Power Supply Rejection |
PSR |
100 |
|
|
mVpp |
6 |
Note:
1. AC coupled.
2. Or open circuit.
3. Into 100 ohm differential termination.
4. 20 – 80 %
5. LOS is LVTTL. Logic 0 indicates normal operation; logic 1 indicates no signal detected.
6. All transceiver specifications are compliant with a power supply sinusoidal modulation of 20 Hz to 1.5MHz up to specified value applied through the power supply filtering network shown on page 23 of the Small Form-factor Pluggable (CWDM SFP) Transceiver Multi-Source Agreement (MSA), September 14, 2000.
Optical Parameters (TOP =-40 to85°C, VCC = 3.135 to 3.465 Volts)
|
Parameter |
Symbol |
Min. |
Typical |
Max. |
Unit |
Note |
|
Transmitter Section: |
||||||
|
Center Wavelength |
λc |
λ-6 |
λ |
λ+7.5 |
nm |
|
|
Spectral Width |
σ |
|
|
1 |
nm |
|
|
Optical Output Power |
Pout |
0 |
|
5 |
dBm |
1 |
|
Optical Rise/Fall Time |
tr / tf |
|
|
500 |
ps |
2 |
|
Extinction Ratio |
ER |
10 |
|
|
dB |
|
|
Generated Jitter (peak to peak) |
JTXp-p |
|
|
0.07 |
UI |
3 |
|
Generated Jitter (rms) |
JTXrms |
|
|
0.07 |
UI |
3 |
|
Eye Mask for Optical Output |
Compliant with G.957(class 1 laser safety) |
|
||||
|
Receiver Section: |
|
|||||
|
Optical Input Wavelength |
λc |
1260 |
|
1620 |
nm |
|
|
Receiver Overload |
Pol |
-8 |
|
|
dBm |
4 |
|
FX Sensitivity |
Sen |
|
|
-34 |
dBm |
4 |
|
FX_LOS Assert |
LOS A |
-47 |
|
|
dBm |
|
|
FX_LOS De-assert |
LOS D |
|
|
-37 |
dBm |
|
|
FX_LOS Hysteresis |
LOSH |
0.5 |
|
|
dB |
|
|
General Specifications: |
||||||
|
Data Rate |
BR |
|
155 |
|
Mb/s |
|
|
Bit Error Rate |
BER |
|
|
10-12 |
|
|
|
Max. Supported Link Length on9/125μmSMF@155Mb/s |
LMAX |
|
80 |
|
km |
|
|
Total System Budget |
LB |
29 |
|
|
dB |
|
Note
1. The optical power is launched intoSMF.
2. 20-80%.
3. Jitter measurements taken using Agilent OMNIBERT 718 in accordance with GR-253.
4. Measured with PRBS 27-1 at 10-12 BER
Mechanical Dimensions
Mechanical Drawing
Order Information:
In the Part No. ofRSPD-01C120-xx,xx stands for central wavelength, such as:
27: for 1270nm, 29: for 1290nm, 31: for 1310nm,……61: for 1610nm.
工作温度：商业级/工业级/军品级可选
本产品为 北亿纤通 | F-tone Networks FT-81系列产品线，详细信息，请联系我们的销售人员，谢谢！Important Notice Performance figures, data and any illustrative material provided in this data sheet are typical and must be specifically confirmed in writing by Andxe System before they become applicable to any particular order or contract. In accordance with the Andxe System policy of continuous improvement specifications may change without notice.The publication of information in this data sheet does not imply freedom from patent or other protective rights of Andxe System or others. Further details are available from any Andxe System sales representative.
